You will need:
Step 1. Ensure the unit is powered off. Unscrew the back lid.
Notice that the front 2 screws are shorter. These should be stored separately.
Step 2. Unscrew the locking nuts (5.5 nut driver needed). If the nut spins around continually with out loosening, you may need to tighten up the standoff (this is done underneath the unit with a 2.0 hex driver).
Step 3. Unscrew the option card plate at the back of the unit. There are 4 black M2.5 in the corners.
Step 4. Unplug the molex power cables from the card. Remove the 2 black cables entirely.
Step 5. Place an anti static/ insulating material on the front lid and place the analogue option card upon it.
Step 6. Remove all the ribbon cables. A Spudger may make this easier
Step 8. Insert all the ribbon cables
Step 11. Again, insuring no power cables are pinched under the standoffs, screw the locking nuts in place.
Step 12. Screw the option card plate into the back of the unit
Step 13. Power the unit on and check for shorts. If all LEDs turn on and after 45 seconds you can hear relays click, this means the unit is powering on correctly. If not, double check that no power cables are pinched under the Dante card or that the polarity is the wrong way round.
We respect your privacy. We only collect and use your IP address for currency conversion when using our Shopify integration. This helps us provide the right currency based on your location. We don’t share this data and only keep it for as long as necessary. For our full statement Click Here
